CLS W211 W219 Mercedes E - Class Automobile Control Arms Parts  A2113308107

 
*  We have the advanced machine, skilled employee to guarantee the nice quality. Supply full range of air suspension for car :

1. Air shock absorber / air suspension shock
2. Air compressor pump
3. Mercedes-Benz air suspension repair kits
4. BMW air suspension repair kits
5. Audi air suspension repair kits
6. Land Rover air suspension repair kits
7. Hose crimping machine and dies
8. Air suspension kits /air suspension spring
9. Hydraulic shock absorber
10.  Air suspension valve / air distribution block
11.  Power steering pump
12.  Automobile control arms
13.  Transmission filters
14.  Steering rack

* What is automobile control arm ?
 

   The control arm helps position the vertical center line of the wheel and allows for up and down      movement of the wheel in relation to the vehicle's body.

*Symptoms of Wear or Failure

  Suspension may make a squeaking and/or knocking noise when going over bumps

  Vehicle may wander

  Uneven tire wear

*Related Repair Advice

 In many cases, the control arm must be replaced in order to replace the bushings.

 Replacing the control arm may affect the alignment's settings. We recommend a four-wheel alignment  when a control arm is replaced.

 
* How to get the right item :
 
Method 1 : Show me the chassis No. and engine No.
 
Method 2 : Show me the OEM No. or Parts No.
 
Method 3: Show me the photo
 
 

* More information about control arm

  In automotive suspension, a control arm, also known as an A-arm, is a hinged suspension link between    the chassis and the suspension upright or hub that carries the wheel.

 The inboard (chassis) end of a control arm is attached by a single pivot, usually a rubber bushing. It can  thus control the position of the outboard end in only a single degree of freedom, maintaining the radial  distance from the inboard mount. Although not deliberately free to move, the single bushing does not  control the arm from moving back and forth; this motion is constrained by a separate link or radius rod.

This is in contrast to the wishbone. Wishbones are triangular and have two widely spaced inboard bearings. These constrain the outboard end of the wishbone from moving back and forth, controlling two degrees of freedom, and without requiring additional links.

Most control arms form the lower link of a suspension. A few designs use them as the upper link, usually with a lower wishbone. The additional radius rod is then attached to the upper arm.

Not only we are able to supply large quantity order, but also we can organize small quantity complex order as well.
 

 
* Contact information :
 
Contact number: Ivy Lee

Skype: pnairsuspension

Mobile number / WHATSAPP / WECHAT: +86 13609036725